HoMedics 518731 User Manual - Page 27

TROUBLESHOOTING If any abnormality arises during use, please check the following points SYMPTOMS POSSIBLE CAUSES Unit does not turn on Batteries have when the START/STOP run down. button is pushed. Battery polarities have been positioned incorrectly. CORRECTION Replace them with four new AAA alkaline batteries. Re-insert the batteries in the correct positions. EE measurement error symbol shown on display or the blood pressure value is displayed excessively low (or high). Cuff has been placed incorrectly. Did you talk or move during measurement? Shaking of the arm with the cuff on. Wrap the cuff properly so that it is positioned correctly. Measure again. Keep arm steady during measurement. E1 error symbol shown Air circuit abnormality. on display Cuff tube may not be plugged into monitor correctly. Check cuff connection. Measure again. E2 error symbol shown Inflation pressure Switch the unit off, then on display exceeding 300 mmHg. measure again. E3 error symbol shown Error determining on display measurement data. Measure again. Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page. 26