HoMedics FMS-350HA User Manual - Page 3

Fig. 1 Fig. 2 Fig. 3 Fig. 4 NOTE: This unit may turn off after an extended period of use. If your unit turns off (LED may remain on). If your unit overheats, unplug the unit and let cool for 30 minutes before plugging in again and continuing use. Instructions for Use To reduce the risk of electric shock, this unit is equipped with a polarized plug (one blade wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 1. Plug into a 120-volt outlet. 2. It is highly recommended that you wear socks while using this foot massager. Do not use the unit with shoes. 3. Place massager on the floor in front of your chair or seat and place feet in massager. 4. To activate massage, press the POWER button once (Fig. 1). The button will illuminate white to confirm your selection. The unit will start with both air and knead at low intensity. Air Intensity Button 1. Pressing the AIR INTENSITY button will allow you to adjust the intensity of the air pressure, how firmly it squeezes your feet. (Fig. 2). 2. Press MODE button until AIR INTENSITY button is illuminated. 3. When first turned on, AIR INTENSITY will begin in the lowest setting with the button illuminated dull blue. 4. Pressing the button again will change the foot pressure to medium, indicated by a brighter blue. 5. Pressing the button a third time will change the pressure to high, indicated by the brightest blue. 6. Pressing the button once more will return the pressure to its lowest setting. Mode Button 1. Pressing the MODE button starts the unit with both air and knead in low intensity. Both sides of the button will be illuminated (Fig. 3). 2. Pressing the button again will change the unit to air only. The left side of the MODE button will illuminate blue. 3. Pressing the button a third time will change the unit to knead only. The right side of the MODE button will illuminate green. 4. Pressing the button once more will return the unit to air and knead. AIR INTENSITY, MODE, and KNEAD INTENSITY buttons will all be illuminated. 4 Fig. 5 Caution: To avoid injury and irreparable damage, always remain seated when using massager. Never stand on the unit. Knead Intensity Button 1. Pressing the KNEAD INTENSITY button will allow you to adjust the intensity of the massaging mechanism (Fig.4). 2. Press MODE button until the KNEAD INTENSITY button is illuminated. 3. When first turned on, KNEAD INTENSITY will begin in the lowest setting with button illuminated dull green. 4. Pressing the button again will change the massage intensity to medium, indicated by a brighter green. 5. Pressing the button a third time will change the intensity to high, indicated by the brightest green. 6. Pressing the button once more will return the intensity to its lowest setting. Heat Button 1. To activate soothing heat, first select AIR or KNEAD. Then simply press the HEAT button and it will illuminate red (Fig. 5). 2. To turn heat off, press the button again and the red light will turn off. NOTE: For your safety, heat cannot be turned on unless air and/or knead program is selected. When finished, turn the unit "OFF" and unplug. Maintenance To Store Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed objects. To avoid breakage, DO NOT wrap the power cord around the unit. DO NOT hang the unit by the controller cord. To Clean Unplug the unit and allow it to cool before cleaning. Clean only with a soft, slightly damp sponge. NEVER allow water or any other liquids to come into contact with the unit. • DO NOT immerse in any liquid to clean. • Never use abrasive cleaners, brushes, or strong chemicals that might or might not be flammable and/or damaging to the product to clean. • DO NOT attempt to repair the massager. There are no user serviceable parts. For service, contact the Consumer Relations telephone number listed in the warranty section. 5