HoMedics SS-7000 User Manual - Page 4

Before You Begin The iSoundSpa uses a backup battery system to provide continuous alarm and clock settings in the event of a power failure. When the Backup Battery is installed - In the event of a power failure or the DC cord is accidentally disconnected, the LCD display will not remain lit, but the current time and alarm time settings will be temporarily maintained. One lithium backup battery is already installed prior to shipping. There is a plastic strip under the lithium battery to prevent battery drain in shipping. Remove the plastic strip before setting clock time. Getting Started Setting Clock Time 1. Press the TIME SET BUTTON located on the back of the unit (Fig. 4); hour digit will begin flashing. Turn the SET +/- KNOB until the current hour is displayed. Remember to set the correct AM or PM (an icon in the upper left of the time display is the PM INDICATOR; there is no AM indicator) (Fig. 2). 2. Press the TIME SET BUTTON again; minute digits will begin flashing. Turn the SET +/- KNOB until the current minute is displayed. 3. Press the TIME SET BUTTON again to exit the clock setting mode or after 5 seconds the display will stop flashing to indicate the time is set. Replace Backup Battery One lithium backup battery is already installed prior to shipping.There is a plastic strip under the lithium battery to prevent battery drain in shipping. Remove the plastic strip before setting clock time. 1. Make sure the DC adaptor is connected. Otherwise the time setting may be lost during battery replacement. 2. Open the battery compartment cover located on the bottom of the unit. 3. Insert one 3-volt lithium battery (Model#: CR2025), checking that the positive polarity faces toward you. 4. Close the compartment cover. 6 7