HoMedics UHE-CM180 User Manual - Page 13

Problem, Possible Cause, Solution

Page 13 highlights

TROUBLESHOOTING PROBLEM Peculiar odor Excessive noise White dust accumulation POSSIBLE CAUSE SOLUTION • Unit is new • If unit is in use, the odor may be a dirty tank or old tank water • Old water in water reservoir • Remove the tank cap and let the tank air out in a cool, dry place for 12 hours • Empty the old water, clean the tank, and fill with clean water • Empty any remaining old water and clean the water reservoir • Unit is not level • Low water level • Place unit on a flat, even surface • Check the water level; refill the tank if the water is low • Hard water • Use distilled water Red light illuminates above the clean button • Transducer/Ultrasonic Membrane needs cleaning • Clean reminder needs to be reset • Follow Cleaning the Transducer/ Ultrasonic Membrane instructions in the Cleaning and Care section • Press and hold the clean button until the red LED turns off 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

13
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Peculiar odor
• Unit is new
If unit is in use, the odor
may be a dirty tank or old
tank water
Old water in water reservoir
Remove the tank cap and let
the tank air out in a cool, dry
place for 12 hours
Empty the old water,
clean the tank, and fill
with clean water
Empty any remaining old water
and clean the water reservoir
Excessive noise
Unit is not level
• Low water level
Place unit on a flat,
even surface
Check the water level; refill the
tank if the water is low
White dust accumulation
• Hard water
• Use distilled water
Red light illuminates above
the clean button
• Transducer/Ultrasonic
Membrane needs cleaning
Clean reminder needs to be
reset
Follow Cleaning the Transducer/
Ultrasonic Membrane
instructions in the Cleaning and
Care section
Press and hold the clean button
until the red LED turns off