Homelite HG5000 User Manual - Page 15

assembly WARNING:  Inspect the unit carefully to make sure no damage occurred during shipping. Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury. LOOSE PARTS LIST See Figure 2. The following items are included with the generator: Key No. Description Qty. 1 Wheel 2 2 Spacers 4  Do not discard the packing material until you have ­carefully inspected and satisfactorily operated the p­ roduct.  If any parts are damaged or missing, please call 1-800-242-4672 for assistance. WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury. 3 Bolts 2 4 Axles 2 5 Lock Nuts 2 6 Bottle of Engine Lubricant 1 7 Pins 2 8 Lock nuts 6 9 Feet 2 WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. 10 Handles 2 11 Spark plug wrench (not shown 1 Operator's Manual (not shown 1 TOOLS NEEDED See Figure 3. WARNING: Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury. The following tools (not included or drawn to scale) are needed for assembly:  Utility Knife  13 mm Socket Wrench  11 mm and 17 mm Box End Wrench NOTE: Do not put fuel or lubricant in the generator before installing the legs and wheels. UNPACKING This product requires assembly.  Carefully cut the box down the sides then remove the machine and any accessories from the box. Make sure that all items listed in the packing list are included. NOTE: This machine is heavy and requires a minimum of two people to lift. To avoid back injury, lift with your legs and not your back. NOTE: Do not put fuel or lubricant in the generator before installing the feet and wheels. installing feet See Figure 4.  Raise the end of the generator where the recoil starter is located high enough to gain access to the frame bottom; securely position props underneath to support.  Locate the following items: 2 foot/leg assemblies 4 lock nuts  Insert bolts for a foot/leg assembly through the holes on one side of the frame as shown.  Install nuts and tighten securely.  Repeat with remaining foot. WARNING: installing the wheels See Figure 5. Do not use this product if any parts on the Loose Parts List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury. Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the recoil starter.  Locate the following items: 2 axles 2 wheels 2 lock nuts 2 pins Page 11 - English