Homelite HG5700 User Manual - Page 14
Installing The Wheels, Securing The Handle, Warning
View all Homelite HG5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
assembly installing the wheels See Figure 3. Wheels are provided to assist in moving the generator to the desired location and should be installed on the side opposite the handle. Locate the following items: 2 bolts (3/8-16 x 4-1/4 in.) 6 washers (3/8 in.) 2 spacers (.38 ID) 2 wheels 2 lock nuts (3/8-16) Raise the end of the generator opposite the handle high enough to gain access to the frame bottom; securely position props underneath to support. Insert a wheel spacer into the center of the wheel. Place a washer on the bolt, then slide bolt through the wheel. Thread another washer on the bolt, then slide the bolt through the U-bracket frame on generator. Place a washer on end of bolt. Install nut on bolt and tighten securely. Repeat the process on the other side to install second wheel. securing the handle See Figures 4 - 5. Locate the following items: Handle lock pin Lanyard Attach the lanyard to the handle lock pin and the handle as shown in figure 4. Insert the pin through the hole in the handle and the generator frame to secure handle in place. warning: Do not attempt to lift the unit by the handle assembly. If it is necessary to lift the generator, always grasp by the frame. Use proper lifting techniques to avoid back injury. lock nut u-bracket wheel washer lanyard wheel spacer bolt washer Fig. 3 frame handle lock pin frame Fig. 4 handle handle lock pin hole Fig. 5 Page 14 - English