Homelite UT10660 Getting Started Guide - Page 1
Homelite UT10660 Manual
View all Homelite UT10660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
WARNING: This Engine Starting Procedure is not a substitute for reading the operator's manual.To reduce the risk of injury, user must read and understand operator's manual before using this product. 1 50:1 Ratio = Mix 2.6 oz of 2-cycle engine lubricant (provided) 1 with 1 gallon of fresh gasoline in separate gas container. 1 GALLON GAS SHAKE. Pour into fuel tank. BAR 2 OIL Add bar lubricant to oil tank. 3 O Set ignition switch to RUN (I) position. 4 HOW TO GET STARTED 5 Press fully and release x7 PRIMER BULB 7 times. 6 Pull CHOKE lever to the FULL position. 7 8 9 10 988000564 3-9-12 (REV: 02) Above 50ºF - Pull STARTER 3 times Below 50ºF - Pull STARTER 5 times Push choke lever to RUN position. Make The Most Of Your Purchase! Go to www.homelite.com and register your new tool on-line. Pull STARTER grip and rope until For any questions about operating or maintaining your product, call the Homelite® Help Line ! engine runs. Your Product has been fully tested prior to shipment to ensure your complete satisfaction. Note: 15-30 Allow the saw to run in this position seconds, depending upon the temperature. Troubleshooting tips are available in your operator's manual. 1-800-242-4672 CALL www.homelite.com DEPRESS throttle release then SQUEEZE and release throttle trigger. IMPORTANT: It is normal for chain saws to have bar and chain lubricant under the chassis after operating the saw. This bar and chain lubricant is coming from the clutch cover area and is NOT an indication of a leak. The clutch cover area must be saturated with lubricant to properly lubricate the bar and chain and to ensure the long-term durability of your new chain saw.