Homelite UT26HBV Engine Starting Procedure - Page 1
Homelite UT26HBV Manual
View all Homelite UT26HBV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
WARNING: This Engine Starting Procedure is not a substitute for reading the operator's manual.To reduce the risk of injury, user must read and understand operator's manual before using this product. TO START: 1 2.6 oz. 1 GALLON GAS 50:1 Ratio = Mix 2.6 oz 2-cycle oil with 1 gallon of fresh gasoline in separate gas container. SHAKE. Pour into fuel tank. 2 Slowly press the PRIMER BULB 10x or until fuel appears. 3 SET choke lever to FULL choke. ENGINE STARTING PROCEDURE 4 9 4 Lock throttle/cruise control lever. 5 Pull starter grip and rope until engine attempts to start (4X max.) 6 SET choke lever to HALF choke. 5 7 7 Pull starter grip and rope until engine starts (6X max.) NOTE: If the unit has not started, return to step 3. 8 Allow the engine to warm for 10 seconds, SET choke lever to RUN. 36 8 TO STOP: 9 PRESS and HOLD stop switch until engine stops. TO RESTART A HOT ENGINE: If the engine/unit is already hot: SET choke lever to RUN. Lock throttle/cruise control lever. Pull starter grip and rope until engine starts. 1 2 Make The Most Of Your Purchase! NOTICE: Do not use E15 or E85 fuel in this product. It is a violation of federal law and will damage the unit and void your warranty. Only use unleaded gasoline containing up to 10% ethanol. Go to www.homelite.com and register your new tool on-line. For any questions about operating or maintaining your product, call the Homelite® Help Line! Your Product has been fully tested prior to shipment to ensure your complete satisfaction.Troubleshooting tips are available in your operator's manual. 991000663 2-3-16 (REV:01)