Honeywell 3800G14-USBKITE User Manual - Page 58
Secondary Trigger Mode, Manual Trigger, Automatic Trigger, Presentation Mode
View all Honeywell 3800G14-USBKITE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
RS-232 programmable selections are used by both the primary and secondary interfaces. Changing an RS-232 parameter (e.g., baud rate or parity), while in primary or secondary mode will affect both interfaces. If you want to change the RS-232 settings, refer to the Connecting the Imager with RS-232 Serial Port section on page 1-6. RS-232 Interface Secondary Trigger Mode Manual Trigger: You must press the imager trigger to scan. When not scanning, idle power is maintained. Default = Manual Trigger. * Manual Trigger Automatic Trigger: The imager scans continuously at full power. Automatic Trigger Presentation Mode: The LEDs are off until a bar code is presented to the imager. Then the LEDs turn on automatically to read the code. Presentation Mode uses ambient light to detect the bar codes. Presentation Mode 6 - 2 3800g User's Guide