Honeywell 4600GHD051C-0F00E User Guide - Page 93
Hands Free Time-Out
View all Honeywell 4600GHD051C-0F00E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Low Power Time-Out Timer Scan the Low Power Time-Out barcode to change the time-out duration (in seconds). Then scan the time-out duration (from 0-300 seconds) from the inside back cover, and Save. Default = 120 seconds. If the unit remains idle during the low power time-out interval, the unit goes into low power mode. Whenever the trigger is enabled, the low power time-out timer is reset. Low Power Time-Out Note: This time-out does not begin until the imager time-out setting has expired. Programming Low Power Time-Out in the secondary interface also programs it in the primary interface. Hands Free Time-Out The Automatic Trigger and Presentation Modes are referred to as "hands free" modes. If the imager's trigger is pulled when using a hands free mode, the imager changes to manual trigger mode. You can set the time the imager should remain in manual trigger mode by setting the Hands Free Time-Out. Once the time-out value is reached, (if there have been no further trigger pulls) the imager reverts to the original hands free mode. Note: If you change the time-out duration for the secondary interface, the duration of the primary interface will also be changed. Scan the Hands Free Time-Out barcode, then scan the time-out duration (from 0-300,000 milliseconds) from the inside back cover, and Save. Default = 5,000 ms. Hands Free Time-Out 6 - 7