Honeywell 6150V User Guide - Page 2

Chime and Status Features Voice Chime You can set each Keypad to announce faulted (opened) entry/exit or perimeter zones whenever the control panel's Chime mode is on by turning on the Voice Chime mode. Voice Chime On/Off: Press the [#] FUNCTION + [0] VOICE + [2] VOLUME + [4] keys. When on, any faulted zone(s) causes a voice status annunciation, chime, and display. When off, the sounder will still provide chime when the control's Chime mode is on. Voice Status You can use the STATUS key to announce system status and display any system and/or zone faults (if they exist) by first turning on the Voice Chime mode (see above). When Voice Chime mode is on, pressing the STATUS key displays and announces current system status and zone descriptors (programmed by your installer) of faulted zones. If zone descriptors are not programmed, the respective faulted zone numbers are announced. To Announce Status: Press the [#] FUNCTION + [0] VOICE + [] STATUS key once (Voice Chime mode must be "on"; see above). The respective system status is announced (e.g. "Disarmed Ready to Arm" or "Disarmed Not Ready to Arm"). Note: Status cannot be announced during the Exit Delay period. To Announce Faults: Press the [] STATUS key a second time within 10 seconds of the first press. Up to 3 faulted zones are announced with their zone descriptors, if programmed. If zone descriptors are not programmed, the respective zone numbers are announced. ÊK0022UGV14Š K0022UGV1 12/01 Rev. C 2 Corporate Center Drive, Suite 100 P.O. Box 9040, Melville, NY 11747 Copyright © 2004 Honeywell International Inc. www.honeywell.com/security