Honeywell CT2700 Owner's Manual - Page 5

CT2700 AN ELECTRONIC ROUND ™ PROGRAMMABLE THERMOSTAT Press the thermostat straight on to the wallplate to latch. NOTE: To remove the thermostat from the wallplate, grasp the thermostat on both sides and pull the thermostat straight out. Restore power to the heating/cooling system. 7 PROGRAM YOUR THERMOSTAT The thermostat is preprogrammed for your convenience with the following time and temperature settings, see Table 2. Table 2. Preprogrammed Time/Temperature Settings. Period Start Time Heating Setpoint Cooling Setpoint WAKE 6:00 AM 70°F (21°C) 78°F (25.5°C) SLEEP 10:00 PM 62°F (16.5°C) 82°F (28°C) WAKE is the time period you want the house at a comfortable temperature during the day. SLEEP is the time period you can set for an energysavings temperature while you are sleeping. NOTE: The heating and cooling program times are the same. Changing your cooling WAKE time also changes your heating WAKE time. The following sequence uses the heating program as an example; the System switch is in the HEAT position. To change to the cooling program, move the System switch to the COOL position and enter the cooling temperature settings. NOTE: To exit the sequence at any time, press until End is displayed. 1. Set Current Time a. Press . PM b. Press or to set current time. If you wish to change the preprogrammed time/ temperature settings, follow steps 2 through 6. If not, press the key until End is displayed or the thermostat will automatically return to normal operational mode within five minutes. 2. Set WAKE Time a. Press . AM b. Press or to set desired WAKE time. 3. Set WAKE Temperature a. Press . SET AM b. Press or to set desired WAKE temperature. 4. Set SLEEP Time a. Press . PM b. Press or to set desired SLEEP time. 5. Set SLEEP Temperature SET a. Press . PM b. Press or to set desired SLEEP temperature. 6. Run Program Press . End is displayed for five seconds indicating the end of programming. The thermostat then displays the current time and room PM temperature. 8 OPERATE YOUR THERMOSTAT Display Temperature Setting a. Press or once to display present SET temperature setting. AM After approximately five seconds, the thermostat displays the current time and room temperature. Temporary Change a. Press or until the desired tempera- SET ture is displayed. AM b. TEMPORARY is displayed. The TEMPORARY change is in effect until the next program period. TEMPORARY AM NOTE: To cancel your TEMPORARY change, press until End is displayed. 5 69-1085