Honeywell CT87N Owner's Manual - Page 3

English: Page 1 • Français: Page 6 • Español: Página 11 Subbase and base installation 1. Pull wires through wire hole. Position coverplate on wall, level and mark hole positions. 2. Drill holes (3/16" for drywall, 7/32" for plaster) and tap in supplied wall anchors. 3. Pull wire through coverplate and subbase, position over anchors, then insert and tighten mounting screws. Check level if desired. 4. Apply the large-print labels to the coverplate, matching the labels on the subbase. Large-print subbase switch labels Subbase Coverplate Wiring 1. Match each labeled wire with same letter on terminal. 2. Use a screwdriver to loosen screw terminals, insert bare wire into slots, then tighten screws. 3. Push any excess wire back into the wall opening. Labels don't match? If labels do not match letters on thermostat, see table below. Existing wires R • RH • 4 • V Rc O B G • F W • W1 • H Y • Y1 • M C • X • B Connect to: Terminal "R" [1] Terminal "Rc" [1] Terminal "O" [2] Terminal "B" [2] Terminal "G" Terminal "W" Terminal "Y" Do not use [3] [1] If wires will be connected to both R and Rc terminals, remove metal jumper. [2] Do not connect both O and B if you have a heat pump. Connect only the O wire. Wrap B wire with electrical tape and do not use. [3] Do not use C, X or B. Wrap bare end of wire with electrical tape. [4] If you have two wires, connect wires to R and W. 3 69-1919EFS-04