Honeywell E Owner's Manual - Page 46

Set System selection to Cool

Page 46 highlights

Symptom Cooling does not come on Table 3. Troubleshooting. (Continued) Possible Cause Action The thermostat is part of a Demand Response event. No power to thermostat. System selection is not set to Cool. Cooling setpoint is above room temperature. If thermostat indicates SAVE, wait until energy saving event is complete. To cancel energy saving event, if available, press and hold Run Program. Check that setpoint is below room temperature. Check if circuit breaker is tripped-reset circuit breaker. Check if fuse at fuse box is blown- replace fuse. Check if System switch at equipment is in Off position-set to On position. Wait five minutes for System to respond- (thermostat displays "Wait"). Set System selection to Cool. 69-1538 46

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

69-1538
46
Cooling does not
come on
The thermostat is part of a
Demand Response event.
No power to thermostat.
System selection is not set
to Cool.
Cooling setpoint is above
room temperature.
If thermostat indicates SAVE, wait until
energy saving event is complete. To
cancel energy saving event, if available,
press and hold Run Program.
Check that setpoint is below room
temperature.
Check if circuit breaker is tripped—reset
circuit breaker.
Check if fuse at fuse box is blown—
replace fuse.
Check if System switch at equipment is in
Off position—set to On position.
Wait five minutes for System to respond—
(thermostat displays “Wait”).
Set System selection to Cool.
Table 3. Troubleshooting. (Continued)
Symptom
Possible Cause
Action