Honeywell HPL624 Installation Instructions - Page 1

Honeywell 12 Clintonville Road Northford, CT 06472-1610 http://www.honeywellpower.com HPL624 Power Supply/Battery Charger PN 52263:C 1/10/08 ECN 08-029 Product Installation Document 1 Introduction The HPL624 power supply/battery charger converts a low voltage AC input into an output of 6 VDC or 12 VDC @ 1.2 amps of continuous supply current or 24 VDC @ 750 mA of continuous supply current. This general purpose linear power supply can provide additional power for a variety of applications such as access control, security and CCTV system accessories. 2 Specifications • Switch selectable for 6 VDC, 12 VDC or 24 VDC output. • 1.2 amps of continuous supply current at 6 VDC or 12 VDC.* • 750 mA of continuous supply current at 24 VDC.* • Output that is filtered and electronically regulated. • Built-in charger for sealed lead acid or gel type batteries. • Maximum charge current of 500 mA. If a battery charger is used, subtract max charge current of 500 mA from total to determine allowable load. • Automatic switchover to stand-by battery upon AC fail. • PTC battery protection. • Thermal and short circuit protection with auto reset. • LED indicators for AC input and DC output. • Compact design (board dimension 3"L x 2.5"W x 1.5"H). • Battery leads and foam mounting tape included. *Specified at 25ºC ambient. HPL624.wmf DC LED TB1 BAT + DC - DC + AC AC AC LED 3 Voltage Output and Transformer Selection Output Voltage/Current 12 VDC @ 1.2 amps continuous supply current 24 VDC @ 750 mA continuous supply current 6 VDC @ 1.2 amps continuous supply current Switch SW1 SW2 Closed Closed Open Closed Closed Open Transformer Requirements 16.5VAC / 40 VA (model HTP1640) 24VAC / 40 VA (model HTP2440) 12VAC / 20 VA (model HTP1220)