Honeywell HZ-510 Owners Manual

CERAMIC UTILITY HEATER

Model HZ-510 Series

The Honeywell trademark is used by Kaz, Inc. under license from Honeywell Intellectual Properties, Inc.

IMPORTANT SAFETY

INSTRUCTIONS

When using electrical appliances, basic

precautions should always be followed to

reduce the risk of fire, electric shock, and

injury to persons, including the following:

1.

Read all instructions before using this heater.

2.

This heater is hot when in use.

To avoid burns, do

not let bare skin touch hot surfaces.

If, provided, use

handle when moving this heater.

Keep combustible

materials, such as furniture, pillows, bedding,

papers, clothes, and curtains at least 3 feet (0.9 m)

from the front of the heater and keep them away

from the sides and rear.

3.

Extreme caution is necessary when any heater is

used by or near children or invalids and whenever

the heater is left operating and unattended.

4.

Always unplug heater when not in use.

5.

Do not operate any heater with a damaged cord or

plug or after the heater malfunctions, has been

dropped or damaged in any manner.

Return heater

to authorized service facility for examination,

electrical or mechanical adjustment, or repair.

6.

Do not use outdoors.

7.

This heater is not intended for use in bathrooms,

laundry areas and similar indoor locations.

Never

locate heater where it may fall into a bathtub or

other water container.

8.

Do not run cord under carpeting.

Do not cover cord

with throw rugs, runners, or the like.

Arrange cord

away from traffic area where it will not be tripped

over.

9.

Connect to properly grounded outlets only.

This

heater is for use on 120 volts.

This appliance has a

grounded plug as shown in Fig. 1.

An adapter is

available at retail (not included) for connecting three-

blade grounding-type plugs to two-slot receptacles.

The green grounding lug extending from the adapter

must be connected to a permanent ground such as a

properly grounded outlet box.

The adapter should

not be used if a three-slot grounded receptacle is

available.

10.

This heater draws 12.5 amps during operation.

To prevent overloading a circuit, do not plug the

heater into a circuit that already has other

appliances working.

11.

It is normal for the plug to feel warm to the touch;

however, a loose fit between the AC outlet

(receptacle) and plug may cause overheating and

distortion of the plug.

Contact a qualified electrician

to replace loose or worn outlet.

12.

To disconnect the heater, first turn off the product,

then grip the plug and pull it from the wall outlet.

Never pull by the cord.

13.

Do not insert or allow foreign objects to enter any

ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.

14.

To prevent a possible fire, do not block air intakes or

exhaust in any manner.

Do not use on soft surfaces,

like a bed, where openings may become blocked.

15.

A heater has hot and arcing or sparking parts inside.

Do not use it in the areas where gasoline, paint, or

flammable liquids are used or stored.

16.

Use this heater only as described in this manual.

Any other use not recommended by the

manufacturer may cause fire, electric shock,

or injury to persons.

17.

Avoid the use of an extension cord because the

extension cord may overheat and cause a risk of fire.

However, if you have to use an extension cord, the

cord shall be No. 14 AWG minimum size and rated

not less than 1875 watts.

The extension cord shall

be a three wire cord with a grounding-type cord and

plug connector.

18.

The output of this heater may vary and its

temperature may become intense enough to burn

exposed skin.

Use of this heater is not

recommended for persons with reduced sensitivity to

heat or an inability to react to avoid burns.

19.

SAVE THESE

INSTRUCTIONS

HZ-510_OM_Rev1.qxd

6/22/06

10:59 AM

Page 1

Honeywell HZ-510 Owners Manual

Honeywell HZ-510 - Professional Series Ceramic Heater Manual

Honeywell HZ-510 manual content summary: