Honeywell MK3780-31A62 User Manual - Page 13

Keyboard Wedge

Get Honeywell MK3780-31A62 PDF manuals and user guides View all Honeywell MK3780-31A62 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

INSTALLATION Keyboard Wedge 1. Turn off the host device. 2. Plug the male 10-pin RJ45 end of the PowerLink cable into the 10-pin socket on the MS3780. 3. Disconnect the keyboard from the host device. 4. Connect the "Y" end of the PowerLink cable to the keyboard and the keyboard port on the host PC. If necessary use the male/female adapter cable supplied with the scanner for proper connections. 5. Plug the external power supply into the power jack on the PowerLink cable. Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet. The outlet must be located near the equipment and be easily accessible. Figure 9. 6. Connect AC power to the transformer. 7. Turn on the host device. When the scanner first receives power the white LED will flash, one blue LED will turn on and the scanner will emit one beep. Powering the MS3780 directly from the host device can sometimes cause interference with the operation of the scanner or the computer. Not all computers supply the same current through the keyboard port. For this reason, Metrologic recommends using an external power supply. For additional information contact a Metrologic customer service representative. See Caution statement on page 5. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
9
I
NSTALLATION
Keyboard Wedge
1.
Turn off the host device.
2.
Plug the male 10-pin RJ45 end of the
PowerLink cable into the 10-pin socket
on the MS3780.
3.
Disconnect the keyboard from the host
device.
4.
Connect the “Y” end of the PowerLink
cable to the keyboard and the keyboard
port on the host PC.
If necessary use
the male/female adapter cable supplied
with the scanner for proper connections.
5.
Plug the external power supply into the
power jack on the PowerLink cable.
Check the AC input
requirements of the power
supply to make sure the
voltage matches the AC
outlet.
The outlet must be
located near the equipment
and be easily accessible.
6.
Connect AC power to the transformer.
7.
Turn on the host device.
When the scanner first receives power the white LED will flash, one
blue LED will turn on and the scanner will emit one beep.
Powering the MS3780 directly from the host device can sometimes
cause interference with the operation of the scanner or the computer.
Not all computers supply the same current through the keyboard port.
For this reason, Metrologic recommends using an external power
supply.
For additional information contact a Metrologic customer
service representative.
See Caution statement on page 5.
Figure 9.