Honeywell MK9535-79C5M38 User Guide - Page 7
Quick Start, will hear 3 continuous beeps. After 4 seconds, both the blue LEDs of - scanner
View all Honeywell MK9535-79C5M38 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
QUICK START 1. Connect the 10-pin RJ45 male connector into the 10-pin modular jack on the bottom of the cradle. You will hear a 'click' when the connection is made. 2. Connect the plug of the power supply into the power jack on the bottom of the cradle. 3. Connect the power supply into an AC outlet. The blue LED on the rear of the cradle will stay on. p o n 4. Pick up the scanner and scan the Bluetooth address code on the cradle, you will hear 3 continuous beeps. After 4 seconds, both the blue LEDs of the charger cradle and the scanner flashes, followed by a 3 combination beeps. This means the communication between the cradle and the scanner has been established successfully. q Bluetooth Address Code* *This is a configuration bar code attached on the cradle. Before the normal scanning, you must establish a communication between the scanner and the receiver. Please go to Page 8 for more details. Caution: To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements for SELV ( Safety Extra Low Voltage) according to EN 60950. To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power source should meet applicable performance requirements for a limited power source. 3