Honeywell MS9540-38-3 Configuration Guide - Page 42
Test Modes, No Protocol Prefix and Suffix for Bar Code
View all Honeywell MS9540-38-3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
³ 141715 ³ 141705 ³ 119917 Use Protocol Prefix and Suffix for Bar Code Transmission * No Protocol Prefix and Suffix for Bar Code Transmission Enable RTS on No Read - After a NOREAD occurs, the scanner will activate the RTS line for 20 milliseconds. The duration of the RTS activation can be loaded in address 199 bits 6-0 in 10 millisecond steps. ³ 119907 * Disable RTS on No Read Test Modes ³ 118016 ³ 118006 ³ 115512 ³ 115502 Scan Count Mode ON - The scanner will enter scan count test mode and the scanner's firmware number will transmit to the host. Do not enable unless instructed by a Honeywell representative. * Scan Count Mode OFF Power-Up with Saved Interface - Do not enable unless instructed by a Honeywell representative. * Power-Up with Board Interface - Do not enable unless instructed by a Honeywell representative. 7-10