Honeywell MS9590 Configuration Guide - Page 40
Host Scanner Commands, Enable Z/R Type D/E Simulation - metrologic a
View all Honeywell MS9590 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Host Scanner Commands ³ 118015 ³ 118005 Enable D/E Disable Command - The scanner will disable scanning after it receives an ASCII "D" from the host device. It will enable scanning when it receives an ASCII "E". * Disable D/E Disable. ³ 118211 ³ 118201 Enable Z/R Type D/E Simulation - The scanner will disable scanning after it receives an ASCII "Z" from the host device. It will enable scanning when it receives an ASCII "R". * No Z/R Type D/E Simulation ³ 118014 ³ 118004 Enable F/L Laser Command - The scanner will turn off the laser after the scanner receives an ASCII "F" character. The laser will turn on after it receives an ASCII "L" character. * Disable F/L Laser Command ³ 118115 ³ 118105 Use DTR Scan Disable - The scanner will monitor the DTR input to determine if scanning should be allowed. A +12V active level enables decoding. A -12V inactive level disables decoding. * Do Not Use DTR Scan Disable - Do not monitor the DTR input. ³ 118110 ³ 118100 Activate DC2 Character - Scanning will be initiated with the receipt of a DC2 character (^R, 124). * Do Not Activate on DC2 Character ³ 115917 Transmit "METROLOGIC" with receipt of an "I" (49H) via RS232 ³ 115907 * Don't Transmit "METROLOGIC" with receipt of an "I" (49H) via RS232 7-8