Honeywell NSEK Configuration Guide - Page 15
M-9600 Dial-up Modem, RS-485 Connection
View all Honeywell NSEK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Honeywell Access Systems M-9600 Dial-up Modem, RS-485 Connection Thirty-one NS2 panels for each drop line. NS2 Configuration Guide NStar Server Refer to 485-PCI / NS2 Panel Connection Detail diagram. N-485-HUB-2 Straight Thru Cable (9-25 Pin) M-9600-2 Female 9 Pin (RX) 2 (TX) 3 (Comm) 5 Male 25 Pin 3 (RX) 2 (TX) 7 (Comm) RS-232 (50 Ft.) M-9600-2 RS-485 (4,000 Ft.) Analog Phone Line Dedicated analog phone line recommended DIP Switch Settings S1: ON S2: ON S3: ON S4: ON S5: ON S6: OFF (Ack/Nak on) S7: ON S8: OFF (19,200 Baud Rate) DIP Switch Settings S1-S5: Panel Address S6: ON (RS-485 Enable) S7: N/A (Baud Rate) S8-S9: OFF (Bias) S10: ON (485 EOL) DIP Switch Settings S1-S5: Panel Address S6: ON (RS-485 Enable) S7: N/A (Baud Rate) S8-S9: OFF (Bias) S10: OFF (485 EOL) 7-101004-01 EG DB 9 / DB 25 Connectors Female Male NS2 Panel NS2 Panel See RS-485 Cable note. EG Only Earth Ground (EG) EG one side of cable. EG It is recommended to earth ground (EG) each NS2 enclosure individually. RS-485 Cable RS-485 NS2 Panel NS2 Panel Red/White TB9-1 (RS485+) TB9-1 (RS485+) Black/Green TB9-2 (RS485-) TB9-2 (RS485-) RS-485 COM TB9-3 (RS485 COM) TB9-3 (RS485 COM) 4,000 ft. (1,200 m) max, 24 AWG, 2 twisted pairs with shield, 120 ohm, 23 pf (NCI part no. NCP2441-TN) 15