Honeywell V5100NS Use and Care Guide - Page 7

Troubleshooting Guide If your Humidifier is not working properly, refer to the following: Problem Possible Cause Solution Power Knob is turned "On" and Power Light is off • Unit not plugged in • No power at outlet • Plug unit in • Check circuits, fuses, try a different outlet. Little or no mist is produced • No water in tank • Unit is not level • Mineral deposits on Nebulizer or Water Sensor • Water Tank was washed with detergent • Blower not operating • Demineralization Cartridge is clogged • If New Demineralization Cartridge • Nebulizer not functioning • Fill Water Tank. • Place on a level surface. • Clean Nebulizer and Water Sensor per instructions. • Rinse thoroughly with clean water. Wipe Dry. • Ensure water in Base is adequate to immerse Water Sensor. • Remove Cartridge and restart machine. If mist resumes, replace with a new Cartridge (Model DC-51). • Please allow at least 15 minutes for water to saturate a new demineralization cartridge. • See Warranty Condensation forms around humidifier or windows • Mist Intensity is set too high for room size or preexisting humidity level. • Decrease mist output using the Mist Intensity Control. White dust accumulation • Hard water used • Demineralization Cartridge needs replacement • Use distilled water or a Demineralization Cartridge. • Replace Demineralization Cartridge (Model DC-51) Cannot smell Vicks Soothing Vapors • Scent pad has been in your • Replace scent pad with humidifier for over 8hrs fresh pad Note: Failure to keep this unit clean from mineral deposits normally contained in any water supply will affect the efficiency of operation of this unit. Customer failure to follow these instructions may void the warranty.