Hoover DOKITCHAPP2548527 Manual - Page 5

3-5 3-6 3-7 Brush the surface of filter to remove any clinging litter. (Filter may be washed in warm water. It must be completely dry before replacing in cleaner. Do not use cleaner without filter in place.) 3-8 Push filter back through frame. 3-9 G F Place filter on top of cup as shown and push firmly into cup. 3-10 H I E Place bottom of cup (E) first, then pivot cup into position. Press top of cup to snap it into place. NOTE: Filter must be in place for cup to latch. Final filter How to replace The final filter assists in returning clean air to the room. The filter is located on the side of the cleaner body. When it becomes dirty, it must be replaced. Replace with part no. 59136-022. Disconnect cleaner from electrical outlet. To replace, press down on grill tab (F) and remove grill. Remove the felt filter (G) and replace with a new one. To replace the filter grill, insert tabs (H) at the bottom of the grill into slots (I) in the cleaner body. Press on grill to snap it into position. Powered nozzle How to clean Disconnect cleaner from electrical outlet. To maintain cleaning effectiveness, periodically remove lint, strings, etc. from the brush roll from the bottom of the nozzle. 3-11 Belt The long-lasting belt may never need to be replaced. However, if the belt should break, it can be replaced by contacting your local Authorized Hoover Dealer (Depot) or Hoover Factory Service Center. When to replace Replace the brush roll when the brushes do not touch the edge of a card as it is moved across the opening on the bottom of the nozzle. A new brush roll can be installed by your local authorized Hoover Dealer (Depot) or Hoover Factory Service Center. Lubrication The motor is equipped with two bearings. These bearings contain sufficient lubrication for the life of the motor. Therefore, do not add lubricant to either motor bearing. Continued 5