Hoover F7431 Manual - Page 5
Storing hose and, tools - model
View all Hoover F7431 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1-9 1-10 H G Rotate top of caddy toward cleaner handle. Slide caddy down so notch (G) on caddy rests in hook (H) on cleaner. J I Identify the hose parts before storing hose. I. Nozzle connector end J. Solution tube 1-12 1-13 1-11 I Storing hose and tools Press hose, a few inches from nozzle connector end (I), into caddy. Bring hose up and over top of caddy. 1-14 L K Press hose into opposite side of caddy. Loop hose at bottom of cleaner and press into top of hook (K). Loop hose over top of caddy again. J Press solution tube (J) into outside of clip (L). Loop solution tube up and press into opposite side of clip. 1-15 1-16 1-17 Snap stair/upholstery nozzle onto caddy. Insert top of bare floor tool (available at additional cost if not included with your cleaner) through "loop" on caddy. Slide tool down into place. SpinScrub™ hand tool (not included with all models) The SpinScrub™ hand tool is shipped in a plastic bag for protection. To remove the bag before using the tool, open tool door. Continued § 5