Hoover F7452900 Product Manual - Page 9
Caution, Warning, Important - steamvac upright cleaner
View all Hoover F7452900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
How to Fill (continued) 2.12 Push up on the handle once the tank is back to latch it to the unit. Check tank to make sure it is securely latched. 2.13 There may be a small amount of water (indicated by arrows) on the base when the tank is removed from the unit. This is a normal condition. 2.12 2.13 ! CAUTION ! Detergents contain Anionic and Nonionic Surfactants. Avoid contact with eyes and skin. In case of contact with eyes, flush with cold water for 15 minutes. In case of contact with skin, wash with water. If irritation persists, call a physician. ! WARNING ! Certain oxygenated-type cleaners, such as OxiClean* and TuffOxi** will damage your SteamVac® detergent container (A), Clean Water Tank (B) or Dirty Water Tank (C). Use only HOOVER® SteamVac® Oxy detergent for this purpose. *OxiClean is a registered B A trademark of Orange Glo International, Inc. **TuffOxi is a trademark of C Tuff Products for Pets. Dirty Water Tank (lower tank) The Dirty Water Tank holds the dirty solution that is picked up from the surface being cleaned. 2.14 2.15 When the Dirty Water Tank is full, the automatic shut-off will engage, suction will stop and the tank must be emptied (see Automatic Shut-Off section). G How to Empty Turn cleaner off and unplug from electrical outlet. To prevent possible leaking, remove clean water tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture). 2.14 Turn Dirty Water Tank latches (G) outward (one on each side of tank). Raise handle straight up and lift tank off cleaner. Carry tank to sink or drain. 2.15 Lower handle toward back of tank to unlock lid. Lift lid off tank. IMPORTANT Make sure the tank handle is moved forward to lock the tank lid before putting cleaner in upright position. Failure to secure properly may result in damage to the tank handle and may cause poor suction. Empty tank and reposition lid. For full suction, it is important that the Dirty Water Tank lid is properly secured before cleaning. Raise tank handle to carrying position and place it onto cleaner. Lower handle to front of tank. Turn latches (one on each side of tank) inward to lock tank in place. 9 Actual model may vary from images shown.