Hoover ONEPWR Cordless Hand Vacuum Product Manual - Page 6
Warning
View all Hoover ONEPWR Cordless Hand Vacuum manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY WARNING! Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product with damaged or missing parts could result in serious personal injury. WARNING! Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. If any parts are damaged or missing, please call 800-406-2005 for assistance. OPERATION WARNING! Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. to show the state of charge. The light on the charger will flash. • If the light on the charger flashes red, there is an error with the battery or the charger. Try again or call customer service for support. WARNING! To avoid serious personal injury, always remove the battery pack from the product when cleaning or performing any maintenance. • When charge is complete the lights on the battery will turn off and the light on the charger will be solid. • To remove the battery pack from the charger, press the latches and pull up on the battery pack. Starting/Stopping the Vacuum WARNING! Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. Applications You may use this product for the following purpose: • Light-duty vacuuming of dry surfaces See Figure 3, page 8 • To start the vacuum: slide the ON/OFF switch toward the front of the vacuum. • To stop the vacuum: slide the ON/OFF switch toward the back of the vacuum. Crevice Tool See Figures 4 & 5, page 9 • The crevice tool is stored on the underside of the dirt cup. Installing/Removing the Battery Pack See Figure 3, page 8 • Insert the battery pack into the battery port. • Make sure the latches on each side of the battery pack snap into place and that the battery pack is secured in the hand vac before beginning operation. • Locate the latches on the side of the battery pack and depress both sides to release the battery pack from the hand vac. • To detach the crevice tool, pull it forward and remove it from the dirt cup. • Turn off the vacuum. • Remove the battery pack. • Insert the attachment into the front end of the vacuum dirt cup, making sure the attachment is firmly pushed into place. Removing/Reattaching the Dirt Cup See Figures 6 & 7, page 9 Charging Battery Pack See Figure 2, page 8 • Charge the battery fully before first use. This will take up to 3 hours. Due to federal regulations, the battery does not come fully charged. • Plug the charger into a power outlet. • Attach the battery pack to the charger by aligning the ribs on the battery pack to the grooves in the charger. Slide the battery pack into the charger. • When charging, the lights on the battery will illuminate • The dirt cup should be checked, emptied, and cleaned periodically for maximum dust collection. To remove: • Remove the battery pack. • Depress the release button located on top of the hand vac. Pull the dirt cup down and out. To reattach: • Position the two sections as shown. Align the slot on the bottom of dust bowl with the tab on the bottom of motor housing, then snap the two sections together. PG.5