Hoover S2105 Manual - Page 4
Battery recycling
UPC - 073502028018
View all Hoover S2105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
8 9 10 A B Push middle section of filter back into filter frame. Replace filter into dirt cup. Replace dirt cup to cleaner by sitting cup into dirt cup cavity with the black flap (A) on the dirt inlet facing the front of the unit. Then pivot the A dirt cup forward until a snap is felt. Lock in place by sliding the latch (B) toward the center of the nozzle. The brush roll How to clean Turn switch to OFF position. To maintain cleaning effectiveness, periodically remove lint, strings, etc. from the brush roll (A) located on the underneath side of the nozzle. When to replace Replace the brush roll when the brushes do not touch the edge of a card as it is moved across the opening on the bottom of the nozzle. A new brush roll can be installed by 11 A Storage The cleaner may be conveniently hung from the hook (A) located on the top of the upper handle. Turn switch to OFF position before hanging. your local Authorized Hoover Dealer (Depot) or at a Hoover Factory Service Center. Battery recycling Your cleaner contains nickel cadmium batteries. When these batteries no longer recharge, they must be removed from the cleaner and disposed of properly in accordance with state laws as described in Item 14. How to remove battery pack NOTE: Do not remove the batteries to recharge them. The batteries should only be removed if they no 12 A 13 C D E Using a Phillips screwdriver, remove screw (A) on battery door (B). Remove door. Remove battery pack (C) from unit. To disconnect battery pack from terminal, push down on tab (D) and pull connector (E) straight out. To install a new battery pack, push B longer recharge and you plan to replace the batteries or dispose of 4 the cleaner.