Hoover S3592 Manual - Page 3

1. Assembling cleaner This cleaner was inspected and packaged carefully before being shipped from the factory. If you should happen to need assistance during assembly or operation, Visit us online at www.hoover.com to find the service outlet nearest you (follow the service center link) OR Call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) OR Call 1-800-263-6376 to speak with a representative in the Hoover Consumer Response Center. Carton contents 1-1 B C D E A F Connect hose, wand and nozzle 1-2 A B 1-3 F G E Unpack cleaner from carton and identify the parts shown. Remove and dispose of cardboard packing. A. Canister cleaner B. Extension wands and hose C. Power nozzle D. Crevice tool E. Round swivel brush F. Upholstery tool Operate cleaner only at voltage specified on data plate on bottom of cleaner. 1-4 I J D C H KL Connect hose Push the hose connector end (A) into the opening (B) on the front of the cleaner, making sure the prongs (C) on the hose end align with the holes in the opening. When hose end is properly inserted, you will hear a click. To disconnect hose from the cleaner, press the button (D) on the hose connector and pull straight out. Note: The flexible hose contains electrical wires for connection to the power nozzle and should not be used if damaged. The wires should not be seen through the outer skin. Attach wand and power nozzle Push the end of the wand with the button (E) firmly into the hose grip (F), making sure the prongs (G) on the wand align with the holes (H) in the hose grip. When wand is properly inserted, you will hear a click. To remove the wand from the hose, press on the button (E) located on the end of the wand and pull straight out. A second extension wand can be attached in the same manner. Push the opposite end of the wand into the power nozzle (I), aligning the prongs (J) on the power nozzle with the holes (K) in the wand. When the power nozzle is properly inserted, you will hear a click. To remove the power nozzle, press on the button (L) located on the power nozzle and pull straight out. Continued ➠