Hoover Total Home Pet MaxLife Product Manual - Page 14

Belt Replacement

Get Hoover Total Home Pet MaxLife PDF manuals and user guides View all Hoover Total Home Pet MaxLife manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Maintenance Belt Replacement CAUTION To reduce the risk of injury from moving parts, unplug before servicing. WHEN TO REPLACE Replace the belt if it is damaged, cut or broken. Refer to the directions below. HOW TO REPLACE Place the handle in the low position and turn the cleaner over so the bottom side is up. 1 C D 3 Remove the 6 screws as shown with a Phillips screwdriver. Remove the bottom plate. 2 Ensure that the letters printed on the belt are facing you, slide the new belt over the motor shaft (metal rod) (C). Then slip it around the area of the brush roll where no bristles are present (D). 4 Remove the used belt from the brush roll (A) then from the motor B shaft (metal rod) (B) and discard. A With the belt in place, pull the belt and slide the brush roll into the nozzle making sure that the brush roll end caps are in the correct orientation. Place the bottom plate aligning the screw holes and re-install the 6 screws. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
14
Maintenance
Belt Replacement
Remove the 6 screws as shown with
a Phillips screwdriver. Remove the
bottom plate.
Remove the used belt from the
brush roll (A) then from the motor
shaft (metal rod) (B) and discard.
2
Ensure that the letters printed
on the belt are facing you, slide
the new belt over the motor
shaft (metal rod) (C). Then
slip it around the area of the
brush roll where no bristles are
present (D).
3
With the belt in place, pull the belt and slide
the brush roll into the nozzle making sure
that the brush roll end caps are in the correct
orientation. Place the bottom plate aligning the
screw holes and re-install the 6 screws.
4
1
WHEN TO REPLACE
Replace the belt if it is damaged, cut or broken.
Refer to the directions below.
HOW TO REPLACE
Place the handle in the low position and turn
the cleaner over so the bottom side is up.
CAUTION
To reduce the risk of injury from moving parts, unplug before servicing.
A
B
C
D