Hoover U8347 Manual - Page 13

What to buy When purchasing a new agitator brush roll, ask for HOOVER part no. 48414140. How to replace Turn cleaner ON and rotate mode control dial to HARD FLOOR. Turn cleaner OFF and disconnect from electrical outlet. Place handle in upright position and turn cleaner over so bottom side is up. B 41 Pull up on agitator brush roll (B) to remove from brush roll cavity. A ® C 42 Holding agitator brush roll with one hand, slide belt (C) off the agitator. NOTE: Hold on to the belt with one hand. Do not allow the belt to fall back into the cavity on bottom of cleaner. 40 Remove the five screws as shown with a Phillips screwdriver. Lift off bottom plate (A). E D 43 Hold new agitator brush roll in one hand; the belt in the other. Slide the belt onto the agitator brush roll, positioning the belt in the belt guide (D) on the agitator brush roll. 44 Grasp agitator brush roll firmly and fit it into position by first sliding end opposite the belt into the rectangular slot (E) on side of the cleaner. Pull other side of agitator brush roll into place. Turn agitator brush roll making sure belt is not pinched between agitator brush roll and agitator brush roll shield. 45 Reposition bottom plate and five screws. Tighten screws securely. Agitator brush roll belt The agitator brush roll belt is designed to last the lifetime of the cleaner. It typically should not need replacement. If you feel the agitator brush roll belt needs to be checked or replaced, take your cleaner to an Authorized Hoover Sales and Service Center. Do not attempt to remove the agitator brush roll belt. (Cont'd) ¡ 13