Hoover UH30600 Product Manual - Page 10

FILTERS: How to Clean ! WARNING ! To reduce the risk of personal injury, unplug vacuum before servicing. Do not operate cleaner without either the secondary or final filter in place. Secondary Filter 4.5 The secondary filter (A) protects the motor from dirt particles. If filter becomes dirty, pull off grill and lift out filter. Hand wash filter in cold water. Let filter air dry for 24 hours. Reposition dry filter and grill. What to Buy: Secondary Filter Use only genuine HOOVER® Secondary Filter with your vacuum. When purchasing a new Secondary Filter, ask for HOOVER® Part No. 902417001. Final Filter The final filter assists in the filtration process to return clean air to the room. 4.6 To remove the filter, pull tab on filter holder down and remove filter. Lift out filter (B) and hand wash it in cold water. Let filter air dry for 24 hours and reposition it on the side of the filter holder and push filter holder back into cleaner. 4.5 A What to Buy: Final Filter Use only genuine HOOVER® Final Filter with your vacuum. When purchasing a new Final Filter, ask for HOOVER® Part No. 902418001. IMPORTANT Allow filter to dry completely before replacing. Dry filter on edge so air circulates on both sides of filter. This may take up to 24 hours. 4.6 B BRUSHROLL: How to Clean ! CAUTION ! To reduce the risk of personal injury from moving parts, unplug vacuum before servicing. 4.7 A 4.7 Turn vacuum over so bottom side is facing up. Rotate red upper latch (A) counterclockwise. 4.8 Slide (2) lower latches (B) to the unlock position. 4.9 Pivot out bottom plate and remove any debris and/or hair from brushroll. 4.10 Reposition bottom plate, aligning (2) screws on nozzle with lower latches (4.8,B). Press firmly on all front edges (4.10) of nozzle guard to ensure that it is properly seated. Slide (2) lower latches to lock in position, and rotate red upper latch clockwise. 4.9 4.8 B 4.10 Actual model may vary from images shown. 10