Hoover UH70210 Manual - Page 12

headliGht: how to replace (available on select models only) ! WARNING ! To reduce the risk of electrical shock, unplug vacuum before cleaning or servicing. removing lens Press Handle Release Pedal and place handle in low position. 4.21 Using a Phillips screwdriver, remove (2) screws as shown and lift off lens. installing bulb 4.22 Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place. Excessive force is not required. Twisting or turning bulb not required. replacing lens 4.23 Reposition lens and secure with screws. 4.21 what to buy: headlight Additional bulbs may be ordered at Hoover. com or call 1-800944-9200. Ask for Hoover® Part No. 27313-107. 4.22 4.23 belt ! CAUTION ! To reduce the risk of injury from moving parts, unplug vacuum before servicing. 4.24 A The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition. when to replace Replace belt if it is stretched, cut or broken. To check the belt, refer to Fig. 4.24 - 4.26. how to replace 4.24 Turn vacuum over so bottom side is facing up. Rotate red upper latch (A) counter clockwise. 4.25 Slide red lower latch (B) to the unlock position. 4.26 Lift off bottom plate. 4.27 Remove used belt from brushroll (C) then from motor shaft (metal rod) (D) and discard. 4.26 4.25 b 4.27 DC Actual model may vary from images shown. 12