Hotpoint AH12H09E3B Installation Instructions - Page 5

Controls, USING THE AIR CONDITIONER, Features

Page 5 highlights

USING THE AIR CONDITIONER Controls Remote Thermostat Accessory NOTE: :KHQWKHXQLWLVFRQWUROOHGE\DUHPRWHZDOO WKHUPRVWDW VHHSDJHVDQG WKHXQLWZLOOGLVSOD\³/&´ The optional accessory included with the unit stating the XQLWLV³&RQWUROOHGE\:DOO0RXQWHG7KHUPRVWDW´FDQEH installed at the controls to inform the guest. NOTE:)RUVRPHIXQFWLRQVWKHUHLVDVHFRQGGHOD\ after pressing a button. NOTE: :KHQWKHUHDUHGLIIHUHQFHVUHJDUGLQJWKHXQLW function between the Owner's Manual and Remote Thermostat the description in the Owner's Manual shall prevail. C F Controlled by Wall Mounted Thermostat Features This unit has many features. The servicer must be familiar with these features in order to properly service the unit. Compressor Restart Delay 7KLVIHDWXUHH[WHQGVWKHRYHUDOOOLIHRIFRPSUHVVRUE\ SUHYHQWLQJWKHVKRUWF\FOLQJRIWKHDLUFRQGLWLRQHU:KHQ the compressor starts, the unit is designed to run a PLQLPXPRIPLQXWHV7KHFRPSUHVVRUZLOOWKHQEHRII IRUDPLQLPXPRIPLQXWHVWRHTXDOL]HWKHUHIULJHUDQW pressure before restarting. Memory The unit has a memory. If power is lost, all of the control settings (mode, fan speed, on/off and configuration) are UHPHPEHUHG:KHQSRZHULVUHVWRUHGDIWHUDSRZHU failure, the unit will start in the mode (and configuration) it was in when power was lost. Automatic Evaporator Freeze Protection $VHQVRURQWKHLQGRRUFRLOPRQLWRUVWKHFRLOWHPSHUDWXUH and will turn the compressor off until the coil warms up. The indoor fan will continue to run. Automatic Quick Warm-up (for heat pump models only) If the room temperature falls to 8°F below the set point temperature, the reverse cycle heat is shut off and the electric strip heat is turned on for one cycle, until room temperature is satisfied. LED Indicators and Buttons 7KHXQLWKDV/('VWKDWFRUUHVSRQGWRWKHPRGHIDQ VSHHGSRZHUDQGVHWSRLQWRSHUDWLRQWRLQGLFDWHWKHXQLW¶V VWDWXV/('VIRU+,*+0('DQG/2:LQGLFDWHWKHIDQ VSHHGWKDWLVVHOHFWHG/('VIRU)$1&22/DQG+($7 LQGLFDWHZKDWRSHUDWLQJPRGHLVDFWLYH/('IRU32:(5 LVWKHXQLW212))VWDWXV/(',IWKHXQLWLVLQ21PRGH WKH/('ZLOOEHJUHHQ,IWKHXQLWLV2))WKH/('ZLOOEH off. High Temperature Protection in Heating Operation The compressor and(or) electric heater will be switched off to prevent damage in high indoor air temperatures or when there is a defective indoor temperature sensor. Unit Configuration - °F or °C 7KHXQLWFDQGLVSOD\LQHLWKHUƒ)RUƒ&6HHSDJH 49-5000684 Rev. 1 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

49-5000684
Rev. 1
Controls
USING THE AIR CONDITIONER
NOTE:
The optional accessory included with the unit stating the
installed at the controls to inform the guest.
NOTE:
after pressing a button.
NOTE:
function between the
Owner’s Manual
and
Remote
Thermostat
the description in the
Owner’s Manual
shall
prevail.
Remote Thermostat Accessory
Controlled by Wall Mounted Thermostat
C
F
Features
This unit has many features. The servicer must be
familiar with these features in order to properly service
the unit.
Compressor Restart Delay
the compressor starts, the unit is designed to run a
pressure before restarting.
Memory
The unit has a memory. If power is lost, all of the control
settings (mode, fan speed, on/off and configuration) are
failure, the unit will start in the mode (and configuration)
it was in when power was lost.
Automatic Evaporator Freeze Protection
and will turn the compressor off until the coil warms up.
The indoor fan will continue to run.
Automatic Quick Warm-up
(for heat pump models only)
If the room temperature falls to 8°F below the set point
temperature, the reverse cycle heat is shut off and the
electric strip heat is turned on for one cycle, until room
temperature is satisfied.
LED Indicators and Buttons
off.
High Temperature Protection in Heating Operation
The compressor and(or) electric heater will be switched
off to prevent damage in high indoor air temperatures or
when there is a defective indoor temperature sensor.
Unit Configuration - °F or °C