Hotpoint GSM1800NBB Use and Care Manual / Warranty - Page 13

Safety Instructions Operating Instructions Before you call for service... ge.com Problem Spots and filming on glasses and flatware Cloudiness on glassware Black or gray marks on dishes Yellow or brown film on inside surfaces White film on inside surfaces Dishes don't dry Dishwasher won't run Steam Possible Causes What To Do Extremely hard water Low inlet water temperature Overloading the dishwasher • Use Jet-Dry ® and Cascade Crystal Clear ® rinse agents to remove spots and prevent new film buildup. • To remove stubborn spots and pre-existing film from glassware: Improper loading Old or damp powder detergent Rinse agent dispenser empty Too little detergent 1 Remove all metal utensils from the dishwasher. 2 Do not add detergent. 3 Select the POTS & PANS cycle. 4 Start the dishwasher and allow to run for 30 minutes. Dishwasher will now be in the main wash. 5 Open the door and pour 2 cups (500 ml) of white vinegar into the bottom of the dishwasher. 6 Close the door and allow to complete the cycle. If vinegar rinse doesn't work: Repeat as above, except use 1/4 cup (60 ml) of citric acid crystals instead of vinegar. Combination of soft water and too much detergent • This is called etching and is permanent. To prevent this from happening, use less detergent if you have soft water. Wash glassware in the shortest cycle that will get them clean. Water temperature entering the dishwasher exceeds 150°F • Lower the water heater temperature. Aluminum utensils have rubbed against dishes • Remove marks with a mild, abrasive cleaner. Tea or coffee stains • Remove the stain by hand, using a solution of 1/2 cup bleach and 3 cups warm water. CAUTION Before cleaning interior wait at least 20 minutes after a cycle for the heating element to cool down. Failure to do so can result in burns. An overall yellow or brown film can • A special filter in the water supply line is the only way to correct be caused by iron deposits in water this problem. Contact a water softener company. Hard water minerals • To clean the interior, apply dishwasher detergent to a damp sponge. Wear rubber gloves. Do not use any type of cleanser other than dishwasher detergent because it may cause foaming or sudsing. Cascade® and Electrasol® Automatic Dishwashing Detergents have been approved for use in all GE dishwashers. Low inlet water temperature • Make sure inlet water temperature is correct (see page 7). • Select HEATED DRY. Rinse agent dispenser is empty • Check the rinse agent dispenser. Fuse is blown, or the circuit breaker tripped • Replace fuse or reset circuit breaker. Remove any other appliances from the circuit. This is normal • Steam comes through the vent during washing, drying and when water is being pumped out. Troubleshooting Tips Consumer Support 13