Hotpoint HDA3500NWW Use and Care Manual / Warranty - Page 8

Safety Instructions Operation of electronic models (model GSD4000 Only) Using the Dishwasher Door 1 The door must be closed and locked into place to select a LOAD SELECTION or an OPTION. 2 If the door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until the door is closed and latched into place. Start Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60 seconds later the wash action begins. NOTE: The dishwasher remembers your last cycle so you don't have to reprogram each time. When the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON and display the last settings you selected. If you don't want to change any of the settings, simply touch the START/RESET pad to begin the cycle. Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle. Clean This light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened. Operating Instructions Troubleshooting Tips Flashing Display Lights Lights START RESET What It Means This is normal. The START/RESET pad has been pressed. What To Do Allow the dishwasher to drain and reset before you start a new wash cycle. CLEAN Control Error Press the START/RESET pad to turn off the beeper. If the CLEAN light continues to flash, call for service. PLUS A BEEPING SOUND Control Error PLUS A BEEPING SOUND Press the START/RESET pad to turn off the beeper and the dishwasher will attempt to reset. Restart the wash cycle. If this error continues, turn off the power to the dishwasher at the circuit breaker for 30 seconds. Try the dishwasher again. If the error is still present, call for service. 8 Consumer Support