Hotpoint HTR16BBSLCC Owners Manual - Page 5

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support About the fresh food compartment shelves. www.Hotpoint.com Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models. 2 Lift up and out 1 Tilt up Half-Width Shelves One end of the shelf rests on a molded side-wall support; a bracket on the other end hooks into a track on the rear cabinet wall. To remove, lift the shelf up at front, then off the support and out of the track. To replace, select desired shelf height. With shelf front raised slightly, hook the bracket's top lug into the track, then lower the shelf onto the support. NOTE: The shelf to the right of the track is designed to hook into the right-hand slot; the shelf to the left is designed to hook into the left-hand slot. Full-Width Shelves Some models have a steel wire sliding shelf, a stationary tempered glass shelf or two steel wire stationary shelves. These shelves can be moved to another place in the fresh food compartment. The full-width sliding shelf has stop-locks. When placed correctly on the shelf supports, the shelf will stop before coming completely out of the refrigerator and will not tilt when you place food on it or remove food from it. To remove the full-width shelves, lift the rear of the shelf and pull forward. To remove a full-width shelf when the fresh food compartment door cannot be opened fully, lift the rear of the shelf, pull forward and down, tilt the shelf and take it out. Spillproof Shelves (on some models) Spillproof shelves have special edges to help prevent spills from dripping to lower shelves. To remove or replace the shelves, see the above instructions. 5