Hotpoint HTX21EASKWW Quick Specs - Page 1

HTX21EASKWW Hotpoint® 6.2 cu. ft. capacity aluminized alloy electric dryer DRYER DIMENSIONS (IN INCHES) EXHAUST OPTIONS: 4-way via rear, right, left and bottom. CIRCUIT REQUIREMENTS: An individual, properly-grounded branch circuit, protected by a 30-amp circuit breaker or a time-delay fuse, is required. ELECTRIC DRYER RATING: 240V, 5600W, 60Hz, 24 Amp, 208V, 4400W, 60Hz, 22 Amp INSTALLATION INFORMATION: For complete information, see installation instructions packed with product for current dimensional data. SPECIAL INSTALLATION REQUIREMENTS ALCOVE OR CLOSET INSTALLATION: - If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back. - The dryer MUST be exhausted to the outside. - Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0" either side, 1" front, top and rear - Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed. If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed. - No other fuel-burning appliance shall be installed in the same closet with a gas dryer. BATHROOM OR BEDROOM INSTALLATION: - The dryer MUST be exhausted to the outdoors. - The installation must conform with the local codes, or in the absence of local codes, with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers. MINIMUM CLEARANCES OTHER THAN ALCOVE OR CLOSET INSTALLATION: Minimum clearances to combustible surfaces: 0" both sides, 1" rear 22 1/2" 26 3/4" SIDE VIEW For answers to your Monogram, GE Café™ Series, GE Profile™ Series or GE Appliances product questions, visit our website at geappliances.com or call GE Answer Center® Service, 800.626.2000. 27" POWER CORD 4 1/2" 11 3/4" 44" 37 1/2" 4 1/4" 4" 1 3/4" 3 1/4" 5" REAR VIEW Listed by Underwriters Laboratories Specification Created 5/16