Hotpoint RGB790 Owners Manual - Page 10

Using the oven controls. Throughout this manual, features and appearance may vary from your model. Oven Control, Clock and Timer Features and Settings (on some models) Bake/Temp Recall Pad Touch this pad to select the bake function. Bake Light Flashes while in edit mode-you can change the oven temperature at this point. Glows when the oven is in bake mode. Start/On Pad Must be touched to start any cooking or cleaning function. Display Shows the time of day, oven temperature, whether the oven is in the bake, broil or selfcleaning mode and the times set for the timer or automatic oven operations. The display will show PRE while preheating. When the oven reaches the selected temperature, the oven control will beep and the display will show the oven temperature. If "F-" and a number or letter flash in the display and the oven control signals, this indicates a function error code. If your oven was set for a timed oven operation and a power outage occurred, the clock and all programmed functions must be reset. Kitchen Timer On/Off Pad Touch this pad to select the timer feature. Then press the + and - pads to adjust the timer. Timer Light Flashes while in edit mode-you can change the set time at this point. Glows when the timer has been activated. Flashes again when the time has run out until the control is reset. Clock Pad To set the clock, press this pad twice and then press the + and - pads. The time of day will flash in the display when the oven is first turned on. Start Time Pad (on some models) Use along with the Cooking Time or Self Clean pads to set the oven to start and stop automatically at a time you set. Start Time Light Flashes while in edit mode-you can change the start time at this point. Glows when the function has been activated. The time of day will flash in the display when there has Cooking Time Pad (on some models) been a power outage. Reset the clock. Touch this pad and then touch the + or - pads If the function error code appears during the self-cleaning to set the amount of time you want your food cycle, check the oven door latch. The latch handle may to cook. The oven will shut off when the cooking have been moved, even if only slightly, from the latched time has run out. position. Make sure the latch is moved to the right as far as it will go. Cooking Time Light Flashes while in edit mode-you can change Touch the Clear/Off pad. Allow the oven to cool for one the set time at this point. Glows when the function hour. Put the oven back into operation. If the function has been activated. Flashes again when the time 10 error code repeats, disconnect the power to the range and call for service. has run out until the control is reset.