Hoveround Ventura 4-Wheel Mobility Scooter Owners Manual - Page 18

6. INSPECTION AND MAINTENANCE Suggestion Ask for help from your scooter dealer to inspect or replace the fuse, since the tiller shroud has to be removed first before you can replace the fuse. ▓Tires The condition of the tires depends on how you drive and use your scooter. ♦Inspecting tire tread ♦Please check the tread groove regularly. Replace the tires when the tread groove is less than 0.5 mm. ) Attention １. When tread groove is below 0.5mm it can easily lead to vehicle slippage, making braking distances longer. Therefore replace the tires as early as possible when they do not have sufficient tread depth. ) Attention When conducting maintenance of your vehicle, please turn the power switch to OFF and remove the charger cords. Suggestions ♦ Do not splash water directly to wash your scooter as this could lead to malfunction of the system electrics. ♦ Do not use petrol, solvents or vaporizing solution as these may deform or damage the shrouds. ♦ Do not use wax. 6.4 STORAGE Make sure the vehicle is stored under the following circumstances: - Make sure the seat is set in the "Forward"position - Make sure the Power switch is turned to OFF Suggestion Please store the scooter in a location where it is away from the direct sunlight, rain, or dew. When storing for a long time, please charge the battery to full power and then disconnect the battery terminal. For details inquire to your scooter dealer. 6.5 MOVING ABOUT ♦ Turn the power switch "OFF" before moving. ♦ Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the bumper could cause damage or injury. ♦ For your safety, always ask for help if required. You will need 2 or 3 persons when moving or lifting the vehicle. 17 Rev.2.02.15.13