Hunter 23710 Owner's Manual - Page 2
NOTE: Assembly Methods for, Installer's Choice Hanging System, Step 5-1: Fan Assembly, Low Profile - ceiling fan
View all Hunter 23710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Step 4: Installation of Ceiling Plate A. Install the (3) rubber bushings into the top of the ceiling plate by inserting small side of rubber bushing into the three round holes in the ceiling plate. See Figure 4. RUBBER BUSHING CEILING PLATE Figure 4. Rubber Bushings B. Thread the lead wires through the opening in the ceiling plate and install the ceiling plate to the 2 x 4 brace which supports the outlet box. Use (2) #10 wood screws 3" long and (2) flat washers for mounting. Drill (2) pilot holes for mounting screws 9/64" diameter. See Figure 4A. NOTE: Assembly Methods for Installer's Choice Hanging System Your new Hunter fan can be hung in (2) different manners, one being as a low profile fan and also as a ball type hanging fan. Read Steps 5-1 and 5-2 to decide which style of mounting to use. Step 5-1: Fan Assembly, Low Profile Version A. First, place the canopy trim casting on top of fan as shown in Figure 5. Note that the trim casting will be attached to the top of the canopy after the fan is hung. Next, place the canopy on top of the fan so the hole in the bottom of the canopy fits over the adaptor on the top of the fan. See Figures 5 and 5A. Place the canopy assembly washer inside the canopy with the vertical flange of the washer resting on the inside of the canopy. See Figure 5A. CANOPY RUBBER BUSHING CEILING PLATE FLAT WASHER 3" WOOD SCREW Figure 4A. Installing Ceiling Plate NOTE: When mounting the fan on a vaulted ceiling, make sure that one set of elongated slots in the ceiling plate is aligned vertically with the ceiling joist, or horizontally with the cross brace if a cross brace is used. Be sure one of the threaded screw holes in the side of the ceiling plate is facing down. See Figure 4B. The hook in the ceiling plate should be in the down position. ADAPTOR ASSEMBLY WASHER CANOPY TRIM CASING Figure 5 TOP OF FAN #8-32 SCREW CANOPY VAULTED CEILING CEILING PLATE ROUND HOLE ADAPTOR TOP OF FAN SCREW HOLE HOOK Figure 4B. Vaulted Ceiling NOTE: When attaching ceiling plate to the outlet box support, make certain bushings remain in place. NOTE: Tighten the ceiling plate mounting screws only enough to provide slight compression of the bushings. Do not overtighten. Figure 5A. Low Profile Version B. Position the (3) slots in the canopy assembly washer over the (3) threaded holes in the adaptor. See Figure 5A. C. Secure the canopy to the top of the fan using the (3) #8-32 x 3/4" long screws with lock washers. Make certain all screws are tight. Failure to do so could result in the fan falling. See Figure 5A. FORM NO. 41184-01 10/05 -2- ©2005 HUNTER FAN CO.