Hunter 23970 Owner's Manual - Page 8
For Standard or Angled mounting, For Low Profile mounting, Hanging the Fan
View all Hunter 23970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3 • Assembling and Hanging the Fan WARNING: Fan may fall if not assembled as directed in these installation instructions. 3.1 Unbundle the wires from the fan. For Standard or Angled mounting: 3.2 Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball. 3.3 Loosen the square head setscrew on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers. Skip to step 3.7. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. For Low Profile mounting: Note: For low profile mounting, the downrod is replaced with the low profile washer. 3.4 Remove the setscrew from the adapter. 3.5 Place the low profile washer into the canopy with the lip down. 3.6 Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. Hanging the Fan: Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks. 3.7 Raise the fan and align the slots in the canopy with the hooks on the ceiling plate. 3.8 Place the slots over the hooks to hang the fan. Standard or Angled Mounting Steps 3-2 - 3-3 Downrod Setscrew Canopy Canopy Trim Ring Low Profile Mounting Steps 3-5 - 3-6 Low Profile Screws Green Ground Wire Canopy Trim Ring Low Profile Washer Canopy Low Profile Screw Step 3-6 (Detail) Adapter Low Profile Screw Low Profile Washer 8 42637-01 • 06/17/11 • Hunter Fan Company