Hunter 30085 Owner's Manual - Page 3

Using Your Air Purifier 1. Take the air purifier out of the box and remove the clear plastic protective bag. Place the unit on a firm level floor. 2. Before turning on the air purifier, you need to confirm that the filters are firmly in place and have not become loose during shipping. To check the filters, open the front grill by placing your fingers under the handle and pulling the front grill towards you. The front grill will rest open at about 45º. You can remove the front grill by placing your fingers under the handle and pulling the front grill towards you and then up. 3. Before turning the Air Purifier 'on', you need to open the front grill. To release the front grill, press the buttons on the side until the front grill slides easily over the buttons. 4. The carbon pre-filter is mounted inside the front grill with hook tape. Confirm that it properly covers the grill vents. You may notice a few black particles coming off the pre-filter. Those particles are part of the odor-removing activated carbon and will be collected on the filter during use. 5. Place the front grill back onto the unit. First, line up the tabs on the bottom of the grill with the openings on the purifier base and then push the top of the grill forward until it is closed. NOTE: This unit will not operate unless the grill is in the correct position. 6. Plug the unit into a 120V electrical outlet. Operating Your Air Purifier On/Speed Control: Rotate the Speed Control knob to set the desired speed. A setting of zero (0) indicates that the unit is off, one (1) is low speed, two (2) is medium speed, and three (3) is high speed. The fan speed can be adjusted at any time. Filter Change Calendar: The filter counter is designed to optimize the performance of the air purifer by reminding you when to change the Quietflo™ Filter and pre-filter. See Figure 1. Quietflo Filter Calendar: The Quietflo™ Filter indicator is located at the top of the calendar ring. To set the Quietflo Filter counter, rotate the calendar ring to align the month that you installed the filter with the top indicator. Since the filter is designed for 6 months use, the two indicators will serve as reminders to change the filter every 6 months. Pre-filter Calendar: The inner knob of the filter counter is the pre-filter counter. To use, align the knob with the month that you installed the pre-filter. Figure 1 - Calendar Knob The replace symbol on the inner knob points to the month in which you should install a new pre-filter. The pre-filter is designed for three months of usage. © 2006 Hunter Fan Company  41556-01 7/25/2006