Hunter 30090 Owner's Manual - Page 3

ENGLISH ® 3 Setting Up Your Air Purifier 1. Remove your air purifier from the box and take it out of the clear plastic protective bag. 2. Place your QuietFlo® Air Purifier on a firm, flat floor. 3. Before turning the Air Purifier 'on,' open the front grill. • For Models 30090 & 37090: To release the front grill, place your fingers behind the tabs and pull forward. (Refer to Figure 1.) • For Models 30105: To release the front grill, press the buttons on the side until the front grill slides easily over the buttons. (Refer to Figure 2.) 4. The HEPA Filter is already installed in the correct position, but you need to confirm that it is fully inserted. To remove, grasp the edge of the filter frame and pull it forward. Notice the orientation of the flaps and seal, which should be pressed firmly into the filter opening. 5. The carbon pre-filter is mounted inside the front grill with "hook" tape. Confirm that it covers the grill vents. (Refer to Figure 3.) 6. Place the filter installation reminder sticker on the inside edge of the front grill. Circle the month and write the year of installation for the pre-filter and HEPA Filter. 7. Replace the filter and front grill. Be sure that the bottom grill tabs are in position first, and then push the top of the grill forward until it is closed. The unit is now ready for normal operation. NOTE: This unit will not operate unless the door is placed in the correct position. 8. Plug the unit into a 120V electrical outlet. HEPA Filter ;;;;@@@@ Pre-Filter AIR PURIFIER PARTS 0 1 2 QuietFlo 3 Pre-Filter Filter ReFsieltter HEPA Filter Pre-Filter ;;;@@@ Front Front Grill Grill Pre-Filter Filter ReFsieltter QuietFlo 0 1 2 3 Tabs for opening the front grill Buttons for opening the front grill Figure 1 - Models 30090 & 37090 Figure 2 - Model 30105 Figure 3 Hook Tape Grill Vents Tab Hook Tape 41552_AP_rev 3-11-05.indd 3 3/11/05, 5:41:58 PM