Hunter 30707 Owner's Manual - Page 4

Positioning Your Air Purifier, How The Permalife, System Works - air purifiers

Page 4 highlights

6. Ensure the disk on the back of the front grill knob is facing flat side out. Figure 3. Place the latches over the arms on the unit and gently push the front grill back in place. Twist the knob until the Hunter logo is facing up. PermaLife® filter. Up to 99.95% of particles as small as .5 microns can be captured. The ionizer charges any remaining particles causing them to clump together and fall to the floor or surface where they can be removed by cleaning. Clean, purified air is then released into the room through the side grill. (Figure 4.) POSITIONING YOUR AIR PURIFIER Your new Hunter Desktop Air Purifier can be setup to operate either standing up or turned on it's side. To run the Air Purifier on it's side: 1. Turn the unit off and unplug from power. 2. Locate the Rubber Feet located on the side of the Air Purifier. Figure 5. Side Vent Notch Flat Disk Side Figure 3. 6. Plug the unit into a 120V electrical outlet. HOW THE PermaLife® SYSTEM WORKS PermaLife® Front Ionizer Field Filter Pre-Filter Grill Rubber Feet Figure 4. Figure 5. 3. Turn the unit so that it rests on the rubber Feet. Figure 6. Note: The Hunter logo on the knob of the door can be turned to face upward without unlocking. Vertical Dust and other irritants are pulled into the air purification system by the fan. The washable pre-filter attracts larger particles like, pet dander, hair, and odor causing particles and traps them on the pre-filter. Smaller particles such as dust, mold, and pollen pass through the pre-filter and are captured by the Horizontal Figure 6. 4. Plug your desktop air purifier back in. ©2011 Hunter Fan Co. 4 44041-01 20111010

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

4
©2011 Hunter Fan Co.
44041-01
20111010
4. Plug your desktop air purifier back in.
Figure 6.
Your new Hunter Desktop Air Purifier can be
setup to operate either standing up or turned
on it’s side. To run the Air Purifier on it’s side:
1. Turn the unit off and unplug from power.
2. Locate the Rubber Feet located on the side
of the Air Purifier. Figure 5.
Rubber Feet
Figure 5.
3. Turn the unit so that it rests on the rubber
Feet. Figure 6.
Note:
The Hunter logo on the knob of the
door can be turned to face upward without
unlocking.
POSITIONING YOUR AIR PURIFIER
6. Plug the unit into a 120V electrical outlet.
Dust and other irritants are pulled into the air
purification system by the fan. The washable
pre-filter attracts larger particles like, pet
dander, hair, and odor causing particles
and traps them on the pre-filter. Smaller
particles such as dust, mold, and pollen pass
through the pre-filter and are captured by the
HOW THE PermaLife
®
SYSTEM WORKS
Figure 3.
Flat Disk Side
Side Vent Notch
PermaLife®
Filter
Pre-Filter
Front
Grill
Ionizer
Field
Figure 4.
6. Ensure the disk on the back of the front
grill knob is facing flat side out. Figure 3.
Place the latches over the arms on the
unit and gently push the front grill back in
place. Twist the knob until the Hunter logo
is facing up.
PermaLife
®
filter. Up to 99.95% of particles
as small as .5 microns can be captured.
The ionizer charges any remaining particles
causing them to clump together and fall to the
floor or surface where they can be removed
by cleaning. Clean, purified air is then
released into the room through the side grill.
(Figure 4.)
Horizontal
Vertical