Hunter 30895 Owners Manual - Page 4

Using Your Total Air Sanitizer Initial Setup and Operation 1. Take the Air Sanitizer out of the box and remove the clear plastic protective bag and place the unit on a firm, level surface. 2. Before turning on the Air Sanitizer, you need to confirm that the filter is firmly in place and has not become loose during shipping. To release the door, push down on the Hunter logo on the door to release the front grill. Figure 1. 3. Gently pull the door away from the unit and lift away. Figure 2. 4. The HEPA Filter will be resting inside the unit. If present, remove the plastic bag surrounding the filter and place the filter back into the Air Sanitizer. The filter will say "This side faces you" to indicate the direction the filter should be placed in the unit. Figure 3. Note: If the filter is not seated properly inside the unit, the air sanitizer will not operate. 5. Set the tabs on the each side of the bottom of the door into the notches in the base of the unit and rock the door up until the top of the door makes contact with the magnet. Figure 4. 6. Push the Hunter logo in until the front door "clicks" into place. 7. Plug the unit into a 120V electrical outlet. Operation: See Figure 5. Low speed - Recommended for use when soft background noise is unwanted. 2 Figure 1 Figure 2 Filter Figure 3 Tab Medium speed - Typical usage setting. Soft background noise is not an issue. High speed - Use when quick, efficient results to a room's air quality are desired. OFF - Press the sensor pad until all speed indicator lights are off. This will turn the unit off. The fan speed can be adjusted at any time by touching the sensor pad on the top of the unit. Filter Indicator - When the filter life counter exceeds 4000 hours, the filter indicator will flash red as a reminder that you should check the filter. Touch the sensor pad for 3 seconds to reset the filter counter. 4 44068-01 • 06/30/2011 Notch Figure 4 Indicator Lights Sensor Pad Filter Indicator Figure 5