Hunter 44260 Owner's Manual - Page 15
Remove the wall plate and drill two 3/16
View all Hunter 44260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
installing the thermostat, cont. 4. Remove the wall plate and drill two 3/16" holes where marked. 5. Tap the plastic anchors into the holes until they are flush with the wall. 6. Reposition the wall plate on the wall, pulling the wires through the opening. Insert the mounting screws through the wall plate and into the anchors. Verify that the wall plate is visually level and securely tighten both screws. 15
15
4. Remove the wall plate and drill two 3/16”
holes where marked.
5. Tap the plastic anchors into the holes until
they are flush with the wall.
6. Reposition the wall plate on the wall, pulling
the wires through the opening. Insert the
mounting screws through the wall plate and
into the anchors. Verify that the wall plate
is visually level and securely tighten both
screws.
INSTALLING THE THERMOSTAT, CONT.