Hunter 55042 User Guide - Page 17

Troubleshooting

Page 17 highlights

Troubleshooting www.HunterFan.com 1.888.830.1326 Fan doesn't work • Make sure power switch is on. • Pull the pull chain to make sure it is on. • Push the motor reversing switch firmly left or right to ensure that it is engaged. • Check the circuit breaker to ensure the power is turned on. • Make sure the blades spin freely. • Turn off power from the circuit breaker, then loosen the canopy and check all the connections according to the wiring diagram on page 10. • Check the plug connection in the switch housing. Excessive wobbling • Tighten all of the blade and blade iron screws until they are snug. • Turn the power off, support the fan carefully, and check that the hanger ball is properly seated. • Use the provided balancing kit and instructions to balance the fan. Noisy Operation • Tighten the blade and blade iron screws until they are snug. • Check to see if any of the blades are cracked. If so, replace all of the blades. Lights dim when turned on or do not turn on at all. • Make sure the wattage of the light bulbs installed matches the specifications on the light sockets. 17 M0038-01 • 10/22/12 • © Hunter Fan Company

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17

www.HunterFan.com
1.888.830.1326
M0038-01 • 10/22/12 •
© Hunter Fan Company
17
Troubleshooting
Excessive wobbling
Tighten all of the blade and
blade iron screws until they
are snug.
Turn the power off, support
the fan carefully, and check
that the hanger ball is
properly seated.
Use the provided balancing
kit and instructions to balance
the fan.
Noisy Operation
Tighten the blade and blade
iron screws until they are snug.
Check to see if any of the
blades are cracked. If so, replace
all of the blades.
Fan doesn’t work
Make sure power switch is on.
Pull the pull chain to make sure
it is on.
Push the motor reversing switch
firmly left or right to ensure that
it is engaged.
Check the circuit breaker to
ensure the power is turned on.
Make sure the blades spin freely.
Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 10.
Check the plug connection in
the switch housing.
Lights dim when turned on or
do not turn on at all.
Make sure the wattage of the
light bulbs installed matches
the specifications on the light
sockets.