Hunter 90022 Owners Guide - Page 5
Hunter 90022 Manual
View all Hunter 90022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
OPERATION This appliance is for household use only. 1. Place the fan on a dry, safe, flat surface where it cannot fall or be pulled by the cord. 2. Plug the fan into a grounded 120-volt AC electrical outlet (ordinary household current). DO NOT use any other type of outlet. Make sure that the rated voltage of the fan is the same as the power source before plugging it into the power source. 3. Turn the fan "ON" or "OFF" by sliding the Power/Speed Control to the right or left. The power should always be OFF before unplugging the fan. 4. To select the speed, move the Power/Speed Control from OFF to the desired speed setting: O (off), I (low), II (medium), III (High). 5. To control the upward and downward direction of airflow, loosen the screw on the side of the fan housing neck. Adjust to the desired angle and tighten the screw. 6. To make the fan oscillate, push the oscillation knob down. To stop oscillating, pull the oscillation knob up. The oscillation knob is located on the top of the fan housing, near the handle. Handle Oscillation Knob Motor Housing Up/Down Adjustment Screw Base Power/Speed Control Switch FIGURE 3 41479-01 01/06/2005 5 41479-01 Rev 01-06-05.pmd 5 1/6/05, 5:06 PM