Husqvarna 11524E Owners Manual - Page 9

GASOLINE FILLER CAP MUFFLER CHOKE CONTROL OPERATION ELECTRIC START BUTTON AUGER CONTROL LEVER RECOIL (AUXILIARY) STARTER HANDLE DISCHARGE CHUTE CONTROL LEVER DRIVE SPEED CONTROL LEVER DEFLECTOR REMOTE CONTROL LEVER TRACTION DRIVE CONTROL LEVER CHUTE DEFLECTOR PRIMER SAFETY IGNITION KEY FUEL SHUT-OFF VALVE THROTTLE / ENGINE CONTROL DISCHARGE CHUTE CLEAN-OUT TOOL LH TURN TRIGGER LIGHT HANDLE KNOB NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT. MUFFLER TOOLBOX DRIFT CUTTER AUGERS SKID PLATE FIG. 10 MEETS A.N.S.I. SAFETY REQUIREMENTS Our snow throwers conform to the standards of the American National Standards Institute. Toolbox - used to store spare shear bolts, locknuts and wrench. Drive speed control lever - used to select forward or reverse motion and speed of snow thrower. Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage powerpropelled forward or reverse motion of snow thrower. Electric start button - used for starting the engine. LH and RH turn triggers - used to steer the snow thrower. Recoil (auxiliary) starter handle - used for starting the engine. Auger control lever - used to engage auger motion (throw snow). Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine. Discharge chute control lever - used to change the direction the snow is thrown. Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine. Skid plate - used to adjust height of scraper bar from the ground. Choke control - used for starting a cold engine. 9 Drift cutter - used to cut through deep snowdrifts.