Husqvarna 223L Owners Manual - Page 10
Assembly - trimmer head
View all Husqvarna 223L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Fitting the loop handle ASSEMBLY Fitting the trimmer guard and trimmer head • Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft. • Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (L). • Fit the screw, securing plate and wing nut as shown in the diagram. • Tighten the wing nut. Fitting the trimmer head When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. • Fit the drive disc (B) on the output shaft. • Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing. • Insert the locking pin (C) in the hole to lock the shaft. • Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation. H H WARNING! Never use a cutting attachment ! without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. • To dismantle, follow the instructions in the reverse order. 10 - English